1875072C91 for Ford F-Series Common Rail Injector
September 13, 2025
5C3Z9VE527BRM for Ford Powerstroke 7.3L Diesel Fuel Injector
September 13, 2025
1899239C92 for International MaxxForce 7 Fuel Injector
Key Information
Part Number: 1883110C1, 1883111C92, 1899239C92, 5010359R93, AP64901
Engine Make: Navistar
Inspection Report: Yes
Warranty: 14 Months
Supply Ability: In stock
Payment Way: Paypal, Western Union, Visa, Mastercard, T/T
Details: One model in a neutral box or specific box required by clients.
Key Details About the 1899239C92 Fuel Injector:
-
Application: Designed for the MaxxForce 7 (MF7) engine (based on the VT365/MaxxForce DT architecture).
-
Function: Delivers precise amounts of fuel into the combustion chamber for optimal engine performance.
-
Compatibility:
-
Fits 2004–2009 models (may vary depending on engine serial numbers).
-
Cross-references with other Navistar part numbers (confirm with a dealer or parts catalog).
-
Common Issues with MaxxForce 7 Injectors:
-
Clogging due to poor fuel quality.
-
Leaks or electrical failures.
-
Faulty injectors can cause hard starts, misfires, excessive smoke, or reduced power.
Recommended Actions:
Verify Compatibility — Check your engine serial number with an International dealer or parts system.
Diagnose Properly — Use diagnostic tools (like International’s Diamond Logic) to confirm injector failure before replacement.
Buy from Reputable Sources — Ensure you get genuine or high-quality aftermarket injectors (counterfeit parts are common).
Consider Professional Installation — Fuel injector replacement requires proper calibration and torque specs.
Here's a summarized table of the technical parameters for the 1899239C92 International MaxxForce 7 fuel injector:
| Parameter | Specification |
|---|---|
| Part Number | 1899239C92 (Navistar OEM) |
| Engine Application | International MaxxForce 7 (MF7) / VT365 |
| Type | Electro-hydraulic (HEUI – Hydraulically Actuated Electronic Unit Injector) |
| Voltage | 12V (Typical for solenoid control) |
| Flow Rate | Varies by calibration; typically ~200-300 mm³/stroke (exact specs depend on ECM programming) |
| Pressure Range | Operates with high-pressure oil (up to ~3,000–4,000 psi for hydraulic actuation) |
| Seal Type | Copper washer or O-ring (depends on design) |
| Connector Type | Electrical solenoid connector (2-pin or 3-pin, depending on revision) |
| Torque Specification | Typically 10–15 Nm (7–11 lb-ft) for mounting bolts (verify service manual) |
| Compatibility | Fits 2004–2009 MaxxForce 7 engines (check engine serial number for exact match) |
